Infiltration is performed by injecting 60 cc of Klein solution (normal saline – adrenaline – lidocaine) into the donor site to enable a safe and painless harvest of autologous adipose tissue.
The Tumescence Infiltration Cannula features small, multiperforated openings strategically oriented to allow uniform 360-degree distribution of the solution throughout the donor area.
Outer Diameter (OD): 2.1 mm
Length: 15 cm
2 | FAT HARVESTING
Using dedicated Carraway cannulas, 15–20 cc of subcutaneous fat is harvested. This adipose tissue is essential for the preparation of NanoFat and MicroFat, both of which are key components in regenerative medicine applications. The cannula features non-linear port arrangements near its tip, designed to optimize fat collection. The syringes are equipped with vacuum lock.
3 | GRAVITY DECANTATION (3–5 min)
Use the Nanofat filter as a support for the collection syringe. The tissue is allowed to decant to separate unwanted fractions and isolate the functional fraction, which is rich in mesenchymal stem cells. This process avoids the use of centrifugation, preserving vitality of the cells.
Lipid Layer (Supernatant): Oily upper layer
Adipose Tissue: Middle layer of golden fat which is desired
Fluid Layer (Infranatant): Lower red layer (infranatant) containing blood and tumescent solution, which is unwanted
────────────────────
Before decantation, remove any excess air
Then use the Nanofat filter as support
Allow the adipose tissue in the syringe to decant by gravity for 3 to 5 minutes
Expel the fluid layer beneath the fat (subnatant fluid)
4 | PROGRESSIVE FILTERING
The tissue is progressively micronized until NanoFat is obtained, a fluid and regenerative suspension. This material is particularly indicated for osteoarthritis, meniscal and cartilage lesions, tendinopathies, muscle injuries and volume loss, and neuropathies. Transfer the decanted adipose tissue into a single 20cc syringe using the GEMS Anaerobic Transfer 2.4 mm.
Luer-to-Luer: → Sizes: 2.4 mm (purple), 1.4 mm (blue), and 1.2 mm (green) → Preserves the anaerobic and closed environment of the grafts during sizing. → Designed to produce micronized fat of progressively smaller sizes by passing the tissue back and forth through each transfer 30 times.
Final filtering NanoFat 400nm Take the syringe containing the previously emulsified adipose tissue, connected to the Nano Transfer at the top, and connect an empty syringe on the side. Perform a single transfer of the material to obtain the NanoFat (TNF).
5 | INJECTION
NanoFat is easily injectable with very fine needles (27G or 30G), allowing both superficial and deep treatments, making it ideal for applications in Sports Medicine as well.